$ sudo smartctl -a /dev/sda
smartctl 6.2 2013-07-26 r3841 [i686-linux-3.12.6-200.fc19.i686.PAE] (local build)
Copyright (C) 2002-13, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 7200.4
Device Model: ST9500420AS
Serial Number: 5VJ68AY2
LU WWN Device Id: 5 000c50 02a34d469
Firmware Version: 0002SDM1
User Capacity: 500,107,862,016 bytes [500 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 7200 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Thu Jan 16 22:32:37 2014 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x73) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
No Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 107) minutes.
Conveyance self-test routine
recommended polling time: ( 3) minutes.
SCT capabilities: (0x103f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 081 079 006 Pre-fail Always - 16524006
3 Spin_Up_Time 0x0003 100 100 085 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 96
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 084 060 030 Pre-fail Always - 238415253
9 Power_On_Hours 0x0032 087 087 000 Old_age Always - 11526
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 96
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 1150
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 4295032839
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 059 050 045 Old_age Always - 41 (Min/Max 33/41)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 6
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 51
193 Load_Cycle_Count 0x0032 097 097 000 Old_age Always - 7756
194 Temperature_Celsius 0x0022 041 050 000 Old_age Always - 41 (0 21 0 0 0)
195 Hardware_ECC_Recovered 0x001a 045 044 000 Old_age Always - 16524006
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 6
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 6
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 271622321745144
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 1781474599
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 671855915
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 1154 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 1154 occurred at disk power-on lifetime: 11526 hours (480 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 40 ff ff ff 4f 00 09:35:48.286 READ FPDMA QUEUED
60 00 70 ff ff ff 4f 00 09:35:48.286 READ FPDMA QUEUED
60 00 20 ff ff ff 4f 00 09:35:48.285 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 09:35:48.284 READ FPDMA QUEUED
61 00 08 ff ff ff 4f 00 09:35:48.283 WRITE FPDMA QUEUED
Error 1153 occurred at disk power-on lifetime: 11526 hours (480 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 28 ff ff ff 4f 00 09:35:45.247 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 09:35:45.246 READ FPDMA QUEUED
60 00 20 ff ff ff 4f 00 09:35:45.246 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 09:35:45.244 READ FPDMA QUEUED
61 00 08 ff ff ff 4f 00 09:35:45.243 WRITE FPDMA QUEUED
Error 1152 occurred at disk power-on lifetime: 11526 hours (480 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 ff ff ff 4f 00 09:35:42.319 WRITE FPDMA QUEUED
60 00 18 ff ff ff 4f 00 09:35:42.318 READ FPDMA QUEUED
60 00 30 ff ff ff 4f 00 09:35:42.318 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 09:35:42.317 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 09:35:42.315 READ FPDMA QUEUED
Error 1151 occurred at disk power-on lifetime: 11526 hours (480 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 90 ff ff ff 4f 00 09:35:39.428 READ FPDMA QUEUED
60 00 58 ff ff ff 4f 00 09:35:39.428 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 09:35:39.426 READ FPDMA QUEUED
60 00 28 ff ff ff 4f 00 09:35:39.426 READ FPDMA QUEUED
60 00 40 ff ff ff 4f 00 09:35:39.425 READ FPDMA QUEUED
Error 1150 occurred at disk power-on lifetime: 11526 hours (480 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 ff ff ff 4f 00 09:35:36.451 WRITE FPDMA QUEUED
60 00 40 ff ff ff 4f 00 09:35:36.451 READ FPDMA QUEUED
60 00 68 ff ff ff 4f 00 09:35:36.450 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 09:35:36.449 READ FPDMA QUEUED
61 00 10 ff ff ff 4f 00 09:35:36.448 WRITE FPDMA QUEUED
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.